Author Message

<  Ask Rotofugi  ~  Custom Blanks

PostPosted: Thu Aug 06, 2009 10:42 pm
User avatarJoined: Thu Aug 06, 2009 10:40 pmPosts: 2
I need a few 6'' Vinyl teeth made. Does anyone know where or how i can do this or get this done?


Offline Profile
PostPosted: Fri Aug 07, 2009 2:41 pm
User avatarJoined: Wed Jan 14, 2009 6:26 pmPosts: 45Location: Baltimore
To get just a few is really going to be a high cost. Most of the money is in moldmaking and set up. If you're not spreading those initial costs over a larger run of product your going to be ready to really pay a premium for each piece.
You may want to think about resin.


Offline Profile
PostPosted: Fri Aug 07, 2009 5:23 pm
User avatarJoined: Thu Aug 06, 2009 10:40 pmPosts: 2
I just did my research. So im going to make my original tooth out of (?) (Im still undecided. i think all of sculpy or plaster of paris). The 1:1 parts mix putty type silicone mold material and then AeroMarine Polymer Casting Resin for the actual teeth i make after that. the blam bam done!

NH


Offline Profile
PostPosted: Fri Aug 07, 2009 6:10 pm
User avatarRoto HelperJoined: Tue Feb 15, 2005 12:34 amPosts: 157Location: chicago
Definitely sculpey! It's about as easy as modeling clay (except for the fumes), and it lasts. You can probably find almost everything you need at a good crafts-n-hobbies store, too.


Offline Profile

Display posts from previous:  Sort by:

All times are UTC - 6 hours [ DST ]
Page 1 of 1
4 posts
Users browsing this forum: No registered users and 1 guest
Search for:
Forum locked  This topic is locked, you cannot edit posts or make further replies.
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
cron